Dremel 9906 3.2mm Tungsten Carbide Cutter - 5 Pieces

Ideal for shaping, smoothing or removing material from especially hard materials—including hardened steel, stainless steel, cast iron, nonferrous metals, fired ceramics, plastics and hard woods. For best results, insert the accessory bit all the way into the tool and then back it out slightly before tightening down. This provides plenty of shank for the collet or chuck to hold onto.

Dremel 9906 Tungsten Carbide Cutter Features:

• Secure objects to a stable surface while working.
• Use the sides of the cutter (rather than the tip) for effective cutting.
• The tip cuts poorly and can break under pressure.
• Use higher speeds for hard woods, slower speeds for metals and very slow speeds for plastics (to avoid melting at the point of contact).
• If chattering occurs, increase speed.

Dremel 9906 Specifications:

• Contents: 1 Bit
• Warranty: Product Defects Only
• Description: Tungsten Carbide Carving Bit
• Bit Diameter mm: 3.2 mm
• Max. Operating RPM: Do not run in excess of 35,000 RPM
• Color Code: Teal
• Overall Length: 1.5
• Material: Tungsten carbide
• Bit Diameter Inch: 1/8"
• Shank Diameter: 0.125