Dremel 9901 Tungsten Carbide Cutter - 5 Pieces
Dremel 9901 - Tungsten Carbide Cutter.The tungsten carbide surface can easily catch the side of a hole and break the bit. For best results, insert the accessory bit all the way into the tool and then back it out slightly before tightening down. This provides plenty of shank for the collet or chuck to hold onto. Use higher speeds for hard woods, slower speeds for metals and very slow speeds for plastics (to avoid melting at the point of contact). If chattering occurs, increase speed. Do not use this cutter for drilling holes or for enlarging holes that are less than twice the diameter of the cutter.
This item may qualify for an upto 5% OFF further discount. Check Eligibility.
Dremel 9901 Tungsten Carbide Cutter Features:
- Shapes, smooths or grinds especially hard materials including: hardened steel, stainless steel, cast iron, nonferrous metals, fired ceramics, plastics and hard woods
- A high-speed bit made of tungsten carbide, the hardest material next to diamonds
- Use higher speeds for hard woods, slower speeds for metals and very slow speeds for plastics
- Use the sides of the bit (rather than the tip) for effective cutting
Dremel 9901 Specifications :
- Contents: 1 Bit
- Warranty: Product Defects Only
- Description: Tungsten Carbide Carving Bit
- Bit Diameter mm: 3.175 mm
- Max. Operating RPM: Do not run in excess of 35,000 RPM
- Color Code: Teal
- Overall Length: 1.5
- Material: Tungsten carbide cutters
- Bit Diameter Inch: 1/8"
- Shank Diameter: 0.125
| Model# | 9901 |
|---|---|
| Brand | Dremel |
Log In