PLS5 Laser Tool Features:
- Self-Leveling: Instant and continuous leveling, 5 Laser Beams: Forward, Up, Down, Left and Right.
- Range: +/- 100 feet (+/- 30.5m). LED Indicator: On/Off, Tilt, Battery Low. Accuracy (All Beams): <1/8" at 100 feet,
- Weather Resistant: Splash & Dust Proof (IP54; IEC529).
- Cantilever Design: Allows for easy sight of opposing reference points.
- Advanced Dampening: Limits vibrations for stable reference points. Pendulum Layout Target: Helps with time-saving alignment tasks.
- Tripod Mount: 1/4 x 20 threaded mount in base. Floor Stand: Included floor stand allows for placement on flat surfaces.
- Defective item will replace or repair, no refund
- Magnetic Wall Bracket: Includes magnetic wall mounting bracket
- Compact Carrying Case: Holds all accessories and fits under pickup truck seat.
- Battery Operated: 3 AA batteries (not included).
- Battery Life: +30 hours continuous use
PLS 5 includes:
- PLS5 Laser Unit
- Magnetic Wall Bracket
- Pendulum Target
- Floor Stand
- Compact Carrying Case
- Operating Manual
Where and How PLS Used:
GLAZIERS:
Lay out curtain walls, store fronts, shower doors and more. Place the PLS5 laser on the outside edge of a threshold. The down reference point will be plumb to the up reference point and therefore should be on the outside edge of the top of your door or window frame.
DRYWALL FRAMERS:
Lay out and install track for commercial or residential projects. Using the PLS5 and our target accessory, project 90 degree angles in a fraction of the time. No more 3-4-5. When installing top and bottom track or plates, place the PLS laser directly over the outside edge of your bottom track or plate. The PLS top reference point will mark where the outside edge of your top track or plate should be.
RESIDENTIAL BUILDER
Setting up foundations on a slope is always a challenge. Put the PLS5X laser on the outside corner of your layout, and pull reference points forward and to the side of the PLS5X unit. Layout of interior walls, ceilings, stairways, cabinetry and more can be done quickly and accurately with the PLS laser. Use the PLS laser and your tape measure to establish plumb and level reference virtually anywhere on the job site.
ELECTRICIANS
How would you lay out 50 can lights in a vaulted ceiling? With a PLS laser and a little thought you can reduce your layout time dramatically. Use your PLS3 laser to determine reference points down and up for each light, per dimensioned plans. How much time would it take you to lay out 50 lights in a vaulted ceiling with two people and a plumb bob?
ACOUSTIC CEILING CONTRACTORS
Use our PLS360 to lay out T bar and grid. Push the button and your self leveling PLS360 gives you a complete level laser line of reference all around the room.
REMODELERS:
Use the PLS2 Palm Laser to determine existing conditions and to lay out cabinetry, fixtures, backsplash, mirrors and more.
STEEL ERECTORS:
No more plumb bobs in the wind. Place the PLS laser on a column and check plumb using your tape measure to read the down and up PLS reference points.
HVAC
Laying out duct work can be difficult on either residential or commercial projects. The PLS laser will speed vertical and level layout, eliminating the wind vs. plumb bob problem. Manipulate plumb, level and square reference anywhere on the job site regardless of obstacles or weather conditions.
| You may also
be interested in: |
|
|
|
|
| |
|
